If you drive by the EGT instead of the temperature gauge in a Vixen TD you will practically eliminate overheating issues and your engine will thank you for it by lasting longer!  This is an upgrade that I can not stress the importance of enough!  If you have a TD you should have an EGT!

This kit includes a LONG braided SS sensor that you install in the exhaust (pre-turbo is best), EGT gauge that matches the dash, wiring harness, gaskets and instructions.  You will need to drill and tap your turbo or exhaust to install the sensor and drill a couple holes in firewall for wiring.  You then need to run the SS cable to the dash and mount the matching gauge in the dash or on the pillar and connect the wires.  

Instructions are available above on the documents tab below the photos.  The instructions are intended for use with our harness so if you are installing someone else's parts, you are assuming all the risk!

Please specify when you order if you have a Garrett or Mitsubishi Turbo and if you'd rather have a digital gauge or a VDO that matches the gauges in the dash.

Garrett says "Air Research"

Mitsubishi says "BMW"